Makes by Mike

Aeotec Multisensor 12v Direct Power

$9.99

Our Aeotec charging system eliminates the need for batteries while hiding power conversion directly within the sensor's battery compartment.  Simply connect a 12v DC power source to the screw terminals and plug the power module into the MultiSensor's USB port.

Note: supports Aeotec's MultiSensor 6.  For other devices, please reach out via our Contact page.

Copyright Notice: All product designs, product documentation, and listing content are owned by Makes by Mike LLC and may not be used in original or derivative form without the express written consent of Makes by Mike. All designs and listing content are @ 2020, Makes by Mike LLC.

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
D
D.M.
Worked perfectly!

This was exactly what I needed. it supplies wired power without having to cut a gynormeous hole in the ceiling to fit a USB plug through. One tiny hole, and some 20 guage wire, and was done. In the attic, I do run 14 gauge from the power supply to each sensor location, then the smaller wire is only about 12" long just to get through and hook up.

J
J.R.
Exactly what I needed.

Lost the usb cable that came with the sensor. This works out so well. Instructions were clear and installation was a breeze. Well made replacement.

You may also like

Recently viewed

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
D
D.M.
Worked perfectly!

This was exactly what I needed. it supplies wired power without having to cut a gynormeous hole in the ceiling to fit a USB plug through. One tiny hole, and some 20 guage wire, and was done. In the attic, I do run 14 gauge from the power supply to each sensor location, then the smaller wire is only about 12" long just to get through and hook up.

J
J.R.
Exactly what I needed.

Lost the usb cable that came with the sensor. This works out so well. Instructions were clear and installation was a breeze. Well made replacement.